Differential D16335 Diff 57232 manual/sculpt_paint/sculpting/tool_settings/remesh.rst

Changeset View

Standalone View

manual/sculpt_paint/sculpting/tool_settings/remesh.rst


	******			******
	Remesh			Remesh
	******			******

	.. reference::			.. reference::

	:Mode: All Paint Modes			:Mode: All Paint Modes
	:Header: :menuselection:`Tool Settings --> Remesh`			:Header: :menuselection:`Tool Settings --> Remesh`
	:Panel: :menuselection:`Sidebar --> Tool --> Remesh`			:Panel: :menuselection:`Sidebar --> Tool --> Remesh`
	:Shortcut: :kbd:`Ctrl-R` (Voxel), :kbd:`Ctrl-Alt-R` (Quadriflow)			:Shortcut: :kbd:`Ctrl-R`

	Remeshing is a technique that automatically rebuilds the geometry with a more uniform topology.			For a general explanation to remeshing, visit the :doc:`Introduction </sculpt_paint/sculpting/introduction>`.
	Remeshing can either add or remove the amount of topology depending on a defined resolution.
	This technique is especially useful for :doc:`sculpting </sculpt_paint/sculpting/index>`,
	to generate better topology after blocking out the initial shape.

	The Voxel Remesher uses an OpenVDB to generate a new manifold mesh from the current geometry.
	It produces a mesh with perfectly even distributed topology and
	it does not have any performance penalty once the new mesh is calculated.
	This makes the voxel remesher great for sculpting has it is possible to
	sculpt at a much higher level of detail than using other features
	like dyntopo which often adds more performance overhead.

	Voxel Size			Voxel Size
	The resolution or the amount of detail the remeshed mesh will have.			The resolution or the amount of detail the remeshed mesh will have.
	The value is used to define the size, in object space, of the :term:`Voxel`.			The value is used to define the size, in object space, of the :term:`Voxel`.
	These voxels are assembled around the mesh and are used to determine the new geometry.			These voxels are assembled around the mesh and are used to determine the new geometry.
	For example a value of 0.5m will create topological patches that are about 0.5m			For example a value of 0.5m will create topological patches that are about 0.5m
	(assuming Preserve Volume is enabled).			(assuming Preserve Volume is enabled).
	Lower values preserve finer details but will result in a mesh with a much more dense topology.			Lower values preserve finer details but will result in a mesh with a much more dense topology.
	▲ Show 20 Lines • Show All 45 Lines • Show Last 20 Lines